1995 Subaru Legacy BaseFACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS

Component Component Location
A/T Control Module Below center of dash.
ABS/TCS Control Module Under carpet between front passenger seat and door sill.
ABS Control Module Under carpet between front passenger seat and door sill.
Cruise Control Module Behind left side of dash.
Daytime Running Lamp Control Module Behind right kick panel.
Engine Control Module (ECM) Below front passenger's footrest. See Figure.
Fuel Gauge Module Below right side of rear seat.
Fuel Gauge Sub Module (AWD) Below left side of rear seat.
Hydraulic Control Unit On lower right front corner of engine compartment.
Hydraulic Unit (TCS) Right side of engine compartment.
Illumination Control Module Behind dash, left of steering column. See Figure.
Security Control Module Behind right side of glove box.
Shift Lock Control Module Behind dash, left of steering column. See Figure.
Sunroof Control Module On center of windshield header.
Transmission Control Module Behind left side of dash.
Turn & Hazard Module In joint box. See Figure.
Chapter Navigation
Return to Chapter: Electrical Component Locator
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.