1994 Subaru Loyale AutomaticFACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS LOCATION

Component Location
A/T Control Unit (4A/T) In trunk, on left rear wheelwell.
Electronic Control Unit (ECU) Below steering column, behind trim panel. See Figure .
Intermittent Wiper Control Unit In center dash console, behind radio (Blue 8-pin connector).
Power Window Control Unit Under front passenger's seat 8-pin connector).
Shift Lock Control Unit (A/T) Behind left kick panel (Black connector).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.