1994 Subaru Legacy AlpineFACTORY OEM SERVICE PROCEDURE

Ignition Timing

  1. Ensure engine is at normal operating temperature and idle speed is correct. Set transaxle in Neutral (M/T) or Park (A/T) position. Connect timing light to No. 1 spark plug wire.
  2. Observe timing marks, located on crankshaft pulley. See 4-CYLINDER IGNITION TIMING SPECIFICATIONS table. If timing is not as specified, check self-diagnostic system for trouble codes. Repair as necessary. See appropriate SELF-DIAGNOSTICS article.
NOTE: When checking timing, CHECK ENGINE warning light will come ON. This is not an indication of a problem. Ignition timing cannot be set if idle contacts in TPS are open and test mode connectors are not connected.
4-CYLINDER IGNITION TIMING SPECIFICATIONS

Application Degrees BTDC @ RPM
Non-Turbo A/T 12-28 @ 700
Non-Turbo M/T 18-22 @ 700
Turbo 7-23 @ 700
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.