1993 Subaru Justy BaseFACTORY OEM SERVICE PROCEDURE

Fuel Injector Circuit Tests: LOYALE

  1. Check Fuel Injector Operation  - Verify injector operation using a stethoscope or screwdriver to hear operating sounds while engine is cranked. If operating sounds are not heard, go to next step. If operating sounds are heard, verify fuel pressure. See FUEL PRESSURE  under FUEL SYSTEM.
  2. Check Fuel Injector Resistance  - Disconnect each injector connector. Verify less than 2 ohms resistance between injector terminals No. 1 and 2. If specified resistance is present, go to next step. If specified resistance is not present, replace fuel injector(s).
  3. Check Injector Harness Resistance  - Verify more than one megohm of resistance between each terminal of injector side of connector and ground. If resistance is not as specified, replace injector(s). If resistance is as specified, replace ECU.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.