Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Subaru Justy BaseFACTORY OEM SERVICE PROCEDURE
6-Cylinder Throttle Position Sensor: SVX
- With ignition off, unplug TPS electrical connector, located at throttle body. Measure and record resistance between TPS terminals No. 1 and 3 with throttle fully closed. See Fig 1 .
- Measure and record resistance between terminals No. 2 and 3 with throttle fully closed, then fully open. If readings are not as specified, replace TPS. See 6-CYLINDER THROTTLE POSITION SENSOR RESISTANCE (SVX) table.
6-CYLINDER THROTTLE POSITION SENSOR RESISTANCE (SVX)
| Application | Ohms | ||
|---|---|---|---|
| SVX | |||
| Terminals No. 1 & 3 | 5000 | ||
| Terminals No. 2 & 3 | |||
| Throttle Fully Closed | 10,000-12,000 | ||
| Throttle Fully Open | 3000-5000 | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.