1993 Subaru Justy BaseFACTORY OEM SERVICE PROCEDURE

4-Cylinder Throttle Position Sensor: Loyale

  1. With ignition off, unplug TPS connector, located at throttle body. Measure and record resistance between terminals "B" and "D". See Figure . Measure and record resistance between terminals "B" and "C" with throttle fully closed, then with throttle fully open.
  2. If necessary, loosen retaining screws and rotate TPS until correct resistance is obtained. Refer to the 4-CYLINDER THROTTLE POSITION SENSOR RESISTANCEΒ  table. Replace TPS if resistance cannot be adjusted to specification.
4-CYLINDER THROTTLE POSITION SENSOR RESISTANCE

Application Ohms
Legacy
Terminals No. 2 & 3 12,000
Terminals No. 2 & 4
Throttle Fully Closed 10,000-12,000
Throttle Fully Open 3000-5000
Loyale
Terminals "B" & "D" 3500-6500
Terminals "B" & "C"
Throttle Fully Closed Less Than 1000
Throttle Fully Open More Than 2400
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.