Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
4-Cylinder Throttle Position Sensor: Legacy
With engine off, disconnect TPS connector. Using ohmmeter, measure resistance between terminals No. 2 and 3 with throttle fully closed. See Fig 1 . Record reading. Measure resistance between terminals No. 2 and 4 with throttle fully closed and then with throttle fully open. Record readings. If readings are not as specified, replace throttle position sensor. See 4-CYLINDER THROTTLE POSITION SENSOR RESISTANCE table.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.