1992 Subaru SVXFACTORY OEM SERVICE PROCEDURE

Anti-Lock Brake System: Operation

As vehicle is driven, each wheel speed sensor sends an AC signal to ABS ECU. As brake pedal is depressed, ABS ECU starts to monitor vehicle rate of deceleration. If rate of deceleration is greater than preprogrammed amount, ABS ECU signals hydraulic control unit solenoid valves to regulate brake hydraulic pressure. Solenoid valves increase or decrease hydraulic pressure to each front wheel and/or to both rear wheels. This action will slow each wheel at a preprogrammed rate to prevent wheel lock-up, allowing driver to maintain steering control.

If ABS malfunction occurs, ABS warning light will come on in instrument cluster panel. ABS ECU will then deactivate ABS system, leaving conventional braking system intact. ABS ECU can also self-diagnose ABS during each ignition cycle (OFF-ON-OFF). If an ABS fault is detected, ABS ECU will store a trouble code to assist technician in diagnosing ABS.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.