1992 Subaru SVXFACTORY OEM SERVICE PROCEDURE

Anti-Lock Brake System: Description

Anti-Lock Brake System (ABS) is designed to prevent wheel lock-up during heavy braking. ABS electronically controls brake fluid pressure, reducing chance of wheel lock-up. This allows driver to maintain better steering control of the vehicle. ABS system consists of 4 wheel speed sensors, 4 tone rings, ABS Electronic Control Unit (ECU), hydraulic control unit, "G" sensor (Legacy 4WD M/T) and ABS warning light. See Figure and Figure .

Two types of hydraulic control units are used. One is manufactured by Bosch; the other is manufactured by Nippon under license from Bosch. The Nippon unit has "F" Valve to prevent brake pedal pulsation when brake fluid pressure decreases.

CAUTION: See ANTI-LOCK BRAKE SAFETY PRECAUTIONS below.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.