Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Subaru Legacy LSi, FWDFACTORY OEM SERVICE PROCEDURE
Idle Speed & Ignition Timing: Notes
Ensure idle speed and ignition timing are set to specification. See IDLE SPEED SPECIFICATIONS and IGNITION TIMING tables. For adjustment procedures, see ADJUSTMENTS article in the ENGINE PERFORMANCE Section.
IDLE SPEED SPECIFICATIONS
| Application | RPM |
|---|---|
| W/Accessories Off | 600-800 |
| W/Accessories On | 800-900 |
IGNITION TIMING (1)
| Application | Man. Trans. | Auto. Trans. | ||
|---|---|---|---|---|
| Non-Turbo | 18-22 @ 700 | 12-28 @ 700 | ||
| Turbo | 7-23 @ 700 | 7-23 @ 700 | ||
|
||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.