1992 Subaru Justy BaseFACTORY OEM SERVICE PROCEDURE

Cruise Control Main Relay

WARNING: This page is about a different car, the 1992 Subaru SVX, 1992 Subaru Legacy, 1991 Subaru Legacy, and 1990 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Relay is located behind right end of instrument panel, next to cruise control unit. Remove relay. Apply battery voltage across relay terminals No. 1 and 3. SeeFig 1 . Check continuity between terminals No. 2 and 4. If there is no continuity, replace relay.

Fig 1: Identifying Cruise Control Main Relay Terminals
G93D02307Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.