1992 Subaru Justy BaseFACTORY OEM SERVICE PROCEDURE

Starter Interlock Relay Test

  1. Interlock relay has a Blue, 4-terminal connector and is located below EFC/MPFI control unit and to far left of unit. EFC/MPFI control unit is located behind drivers left dash panel. Locate and unplug interlock relay.
  2. Connect test light to Black/White wire terminal of interlock relay. Using jumper wire, apply 12 volts to both Black/Yellow wires terminals of interlock relay.
  3. Using another jumper wire connected to ground, momentarily touch jumper wire to Black/Blue wire terminal of interlock relay. Test light should come on. If test light does not come on, replace interlock relay.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.