1992 Subaru Justy BaseFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Miscellaneous

MISCELLANEOUS LOCATION

Component Location
Diagnostic Connectors
Read Memory (Factory) Under left side of dash.
Test Mode On driver's side kick panel or ECU.
Heater Blower Motor Resistor Attached to heater blower motor housing. See Figure .
Ignition Coil Left side of firewall. See Figure .
Noise Suppressor Condenser Left side of firewall. See Figure .
Wiring Harness Diodes - Seat Belt & Interior Light On right side of dash, behind glove box. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.