Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1991 Subaru XT AutomaticFACTORY OEM SERVICE PROCEDURE
Code 41: Air/Fuel Ratio Control System
Code 41 indicates that the mixture is too lean. When no other code is present, all system components are electrically in good working order. Check the following:
- Check injector nozzles for clogging.
- Check fuel pressure.
- Check performance characteristics of coolant temperature sensor.
If the above steps check out okay, perform the next steps.
- Replace airflow meter and drive vehicle. If mixture is still too lean or Code 41 is still present, go to the next step.
- Replace the fuel injectors and drive vehicle. If mixture is still too lean or Code 41 still exists, replace ECU.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
