1989 Subaru RX AutomaticFACTORY OEM SERVICE PROCEDURE

Entering Self-Diagnostics: Notes

"U-Check", "Read Memory" and "D-Check" are entered by connecting and/or disconnecting the read memory and test mode connectors as required. See Fig 3 or Fig 4 . See RELATIONSHIP BETWEEN MODES AND CONNECTORS table.

Fig 1: Location Of O2 Monitor (Except XT)
G118336Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.