1989 Subaru Justy DLFACTORY OEM SERVICE PROCEDURE

Retrieving Codes

  1. Enter specific test mode by connecting or disconnecting "read memory" and/or "test mode" connectors as shown in RELATIONSHIP BETWEEN MODES AND CONNECTORS table.
  2. Observe oxygen sensor monitor light. This light has 2 duration periods of illumination. Long illumination periods of 1.2 seconds designate the tens digit in the numbered codes. Short illumination periods of .2 second designate the ones digit in the numbered codes. Tens and one digits are separated by a .03 second interval of non illumination.
  3. Example: 3 long flashes (1.2 seconds each), followed by 5 short flashes (.02 second each) designate code 35. Code is repeated after a break of 2 seconds, unless another code is present which will be displayed after the 2 second break. Once all codes have been displayed, sequence will repeat.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.