1987 Subaru XT GL, AutomaticFACTORY OEM SERVICE PROCEDURE

Miscellaneous Components

MISCELLANEOUS COMPONENTS LOCATION

Component Location
A/C Amplifier On right side of dash, above A/C-heater housing. See Figure .
A/C Pulse Coil On A/C compressor, above compressor clutch coil. See Figure .
Airflow Meter On air intake duct, near right fender panel. See Figure .
Cruise Control Actuator Attached to right strut tower. See Figure .
Mode Control Actuator On left side of center console, on A/C-heater housing. See Figure .
Pneumatic Suspension Dryer On left fender panel, behind left headlight. See Figure .
Pulse Amplifier On left side of dash, behind instrument cluster.
Resistors
A/C-Heater Blower Motor On A/C-heater blower motor housing.
Auto. Trans. Control Unit On right fender panel.
Engine Control On right fender panel.
Stoplight Check Unit In right rear taillight assembly. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.