Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Subaru XT DLFACTORY OEM SERVICE PROCEDURE
Boost Pressure
- Engine must be at normal operating temperature. Disconnect line from wastegate valve controller. Using a "T" fitting, connect an air pressure gauge. Use enough line so that gauge may be carried inside passenger compartment.
- Boost pressure should be checked at 2400 RPM with a wide open throttle. Normal pressure is 6.4-7.5 psi (.45-.53 kg/cm2 ). Air relief valve should not be leaking air during test.
- If boost pressure is too high, check the rubber hose that connects the intake manifold to the wastegate valve. Replace if defective. If wastegate valve is not operating and remains closed, replace the turbocharger. If boost pressure is too low, replace the turbocharger.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.