Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Subaru BratFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS LOCATION
| Component | Location |
|---|---|
| Cruise Control Unit | On left side of dash, behind instrument cluster. |
| Ignition Module (SPFI) | On left fender panel, under ignition coil. See Figure . |
| Intermittent Wiper Control Unit | On left side of dash, below instrument cluster. See Figure . |
| Knock Control Unit | On right side of dash, behind glove box. See Figure . |
| Multi Point Fuel Injection (MPFI) Control Unit | On left side of dash, below steering column. See Figure . |
| Pneumatic Suspension Control Unit | Under driver's seat. |
| Power Window Control Unit | Under front passenger's seat. |
| Single Point Fuel Injection (SPFI) Control Unit | On left side of dash, below steering column. See Figure . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.