1986 Subaru RXFACTORY OEM SERVICE PROCEDURE

Throttle Sensor

Remove 2 screws securing throttle sensor to throttle chamber. Remove throttle sensor by pulling it in axial direction of throttle shaft. Check "O" ring attached to throttle sensor mounting face of throttle chamber and replace if necessary. Reassemble in reverse order of disassembly.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.