Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Repair and Diagnosis: Transmission: Clutches: Description
The teeth surfaces on the clutch disc's splines are treated with a "Kanigen" coating to improve clutch operation and reduce friction. On the 4WD models, the diameter and width of the clutch disc's spline are increased. The damper characteristics of the clutch disc have been revised to reduce noise and vibration.
On 4WD models, the clutch lever ratio is 3 to 1 to accommodate the high clutch pressure load and improve clutch operation. On 2WD models, the clutch lever ratio is 2 to 1. The release bearing has a self-aligning design. A nickel-phosphorus alloy coating, which results in a hard and even surface treatment and features anti-corrosion characteristics, has been added.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
