Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Throttle Switch
The throttle switch, mounted to the throttle body, works with the throttle shaft. Its idle contact turns on in an idle state and its full contact turns on in a full throttle state. The throttle switch sends signals to the MPFI control unit. The throttle switch has 3 contacts: idle contact, full contact, and moving contact.
The idle contact and full contact are fixed, while the moving contact travels depending on the open angle of the throttle valve. This moving contact is actuated by the groove of the guide cam which is driven by the throttle valve shaft.
When the idle contact is in the "ON" position, the MPFI control unit operates in the "throttle fully closed position". If the full contact is on, the MPFI contol unit operates in the "throttle fully open position". Thus, the full-enrichment mode occurs when full contact is in the "ON" position.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
