1985 Subaru XT GLFACTORY OEM SERVICE PROCEDURE

Federal 4WD Models

  1. Remove hoses from valve and mark for reinstallation. Blow air into valve through slow control air port and check that air flow is blocked at valve port to thermo vacuum valve. See Fig 1 .
  2. Blow air into main control air port and then into port to air cleaner. Check that air flow is blocked at both ports.
  3. Using a vacuum pump, apply 7.9-19.7 in. Hg to valve's port to thermo vacuum valve. With vacuum applied, seal main control air port with finger. Blow air into slow control air port and check that air flows freely through valve.
  4. With vacuum applied, open and blow into main control air port while sealing slow control air port with finger. Check that air flows freely through valve. Replace valve if it does not operate as outlined.
Fig 1: Air Control Vacuum Valve (Federal 4WD Models)
G34078
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.