Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1985 Subaru RXFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Switches
SWITCHES LOCATION
| Component | Location |
|---|---|
| A/C High Pressure Switch | On top of receiver-drier. |
| A/C Low Pressure Switch | On top of receiver-drier. |
| Back-Up Light Switch (M/T) | On side of transaxle rear case. See Figure . |
| Brake/Stoplight Switch | On pedal bracket. |
| Clutch Switch | On clutch pedal bracket. |
| Cooling Fan Cont. Pressure Switch | On top of receiver-drier. |
| Cruise Control Clutch Switch | On clutch pedal bracket. |
| Cruise Cont. Stop & Brake Switch | On brake pedal bracket. |
| Inhibitor Switch (A/T) | At base of shift lever in console. See Figure . |
| Key Warning Switch | In ignition/starter switch. |
| Kickdown Switch (A/T) | On accelerator pedal bracket. |
| Oil Pressure Switch | On oil filter adapter. See Figure & Figure . |
| Parking Brake Switch | On bottom of parking brake lever. See Figure . |
| Seat Belt Switch | On left front seat belt buckle assembly. |
| Throttle Switch | Attached to throttle body on intake manifold. |
| Transaxle Fluid Temperature Switch (A/T) | On side of transaxle extension case. |
| Vacuum Switches (2) | In right rear corner of engine compartment. |
| 4WD Indicator Switch | On transaxle (bottom of selector lever A/T). |
| 4WD Trans. Temperature Switch | On left side of transaxle case. See Figure . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
