1984 Subaru DL 2D HatchbackFACTORY OEM SERVICE PROCEDURE

Ignition System - HITACHI: Description

NOTE: Subaru 4WD Calif. models with manual transmission use Nippondenso ignition systems.

The Hitachi electronic distributor consists of a housing, shaft assembly, rotor and distributor cap. See Fig 1. A reluctor, mounted on upper end of distributor shaft, combines with the stator and pick-up coil to provide ignition timing.

Fig 1: Exploded View: Hitachi Distributor (Subaru 1800 (Non-Turbo), 4WD Vehicles.
G28991

Distributor reluctor rotates past the stator. As each tooth of the reluctor approaches and passes the stator, a signal is sent to the pick-up coil control unit. In response to the signal, the control unit then turns the primary circuit in the ignition coil on and off.

This causes a build-up and collapse of a magnetic field in the coil, resulting in a high voltage surge in the coil's secondary circuit. This fires the spark plugs. See Fig 2 or Fig 3 .

Fig 2: Schematic of Subaru 1800 Non-Turbo Ignition Circuit
G28992
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.