Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1984 Subaru Brat AutomaticFACTORY OEM SERVICE PROCEDURE
Check Valve II
- With check valve II removed, apply compressed air to carburetor side of valve. Confirm that there is no air flow from the carburetor side of the valve to the distributor side. If air flow is noted, replace check valve.
- Apply air to distributor side of valve and confirm that there is air flow to carburetor side. Valve is normal if air flows through.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.