Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1983 Subaru Hatchback 2WD F4-1595cc 1.6LFACTORY OEM SERVICE PROCEDURE
Sevice Manual - Knock Control Unit Correction
84subaru1 NUMBER 01-95-83
DATE 12-7-83
APPLICABILITY: ALL TURBO MODELS
SUBJECT: KNOCK CONTROL UNIT

On page 3-10 of the Subaru Turbo Manual (MSA-440), the diagram of the knock control unit - figure 3-14 is incorrect.
The knock control unit should be shown mounted with the wire harness facing down, as shown below.
Please make a note referring to this bulletin in the applicable Subaru Service Manual.
DATE 12-7-83
APPLICABILITY: ALL TURBO MODELS
SUBJECT: KNOCK CONTROL UNIT
On page 3-10 of the Subaru Turbo Manual (MSA-440), the diagram of the knock control unit - figure 3-14 is incorrect.
The knock control unit should be shown mounted with the wire harness facing down, as shown below.
Please make a note referring to this bulletin in the applicable Subaru Service Manual.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
