1983 Subaru DL 2D HatchbackFACTORY OEM SERVICE PROCEDURE

THERMO Vacuum Valve

  1. Remove thermal vacuum valve from intake manifold. Connect hoses to 2 upper ports and cap lower port. Submerge valve in container of water.
    CAUTION: Do not allow water to enter valve.
  2. With water below 86°F (30°C), blow air through valve. If air does not pass freely, replace valve. Heat water above 104°F (40°C). Replace valve. if air passes through.
Fig 1: Exhaust Gas Recirculation System (2WD Federal Models.)
G43482
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.