1983 Subaru DL 2D HatchbackFACTORY OEM SERVICE PROCEDURE

CALIFORNIA Models

Air is supplied to the exhaust port on the No. 2/No. 4 cylinder side by the air suction valve (ASV-I) with cut-off valve. When coolant temperature is below 95Β°F (35Β°C), the electronic control module signals the solenoid valve to allow manifold vacuum to open the cut-off valve. This enables the suction valve to operate.

The solenoid valve remains open for a period of 123 seconds. During this time, if a low vacuum condition should exist, a check valve is used to maintain vacuum at the solenoid and cut-off valve.

At the end of the 123 second period, the control module turns off the solenoid valve signal. Vacuum is no longer supplied to the cut-off valve and air injection is terminated. See Fig 2 .

Fig 1: Air Injection System (4WD Federal Models)
G41509
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.