Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1982 Subaru Hatchback 4WD F4-1781cc 1.8LFACTORY OEM SERVICE PROCEDURE
Toe-In
Fig. 4 Front toe-in adjustment:
Ensure tires are properly inflated prior to checking or adjusting toe.
FRONT
The following procedure may be used to correct toe-in, if out of specifications.
1. Loosen both left and right tie rod locknuts, Fig. 4.
2. Turn both tie rods an equal amount until toe-in is within specifications.
REAR
Toe cannot be adjusted. If toe is outside specifications, inspect suspension components for damage and replace as necessary.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.