Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1982 Subaru Hatchback 2WD F4-1781cc 1.8LFACTORY OEM SERVICE PROCEDURE
Ignition Switch: Service and Repair
1. Remove steering wheel, then the mast jacket plastic cover held by four screws to expose the switch mounting.
2. Drill two rounded bolt heads then remove bolts with an easy-out.
3. Remove two bolts with conventional hex heads.
4. Pull out switch with clamps.
5. Refit new switch with clamp. If clamp bolts are same as original equipment, tow will have a double-head. The top portion permits tightening with a wrench, and when the necessary torque is reached, the top portion can be snapped off, leaving only the tamper-resistant lower head.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
