Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1982 Subaru Hatchback 2WD F4-1781cc 1.8LFACTORY OEM SERVICE PROCEDURE
Caster
Fig. 1 Caster & camber measurement:
Caster angles are not adjustable, however, the following procedure may be used to ensure caster is within specifications. Ensure tires are properly inflated prior to checking caster angles.
1. Raise front of vehicle and position turning radius gauges under front wheels, then lower vehicle.
2. Install suitable adapter and gauge into center of wheel and measure caster angle, Fig. 1.
3. If caster is not within specifications, inspect suspension components for damage and repair as necessary, then recheck.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.