Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

1982 Subaru GLF Automatic TransFACTORY OEM SERVICE PROCEDURE

Ignition Timing

Adjust timing with engine at normal operating temperature and transmission in neutral. Disconnect and plug vacuum hoses at distributor. With engine at idle, check timing and turn distributor to adjust.

IGNITION TIMING (Degrees BTDC@RPM)

Application	Man.Trans.	Auto. Trans.
All Models	8@700	8@800

Fig 1: Subaru Timing Mark Location

Courtesy of SUBARU OF AMERICA, INC.

Chapter Navigation

Return to Chapter: Tune-Up - 4 CYL

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.