Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Wiper/Washer Systems: Operation
The standard wiper system has 2 speeds. The washer is operated by pushing in the button at the end of the wiper switch. The intermittent system has a third switch position that selects the delayed cycle. No time adjustment is possible.
If the washer button is pressed on this system, the washer will operate and the wipers will run for 4 cycles, then turn off. The rear wiper is operated by the ring on the wiper switch. Turning it to the first position starts the wiper. The second position operates the washer.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.