1981 Subaru GLF Automatic TransFACTORY OEM SERVICE PROCEDURE

Evaporative Emissions System: Operation

When the engine is stopped, fuel vapors flow from the float bowl through the open solenoid valve down into the canister. Vapors from gas expanding in the fuel tank pass through the vapor separator, 2-way valve and into the canister. The purge line check valve is closed to prevent vapors from rising in the line and entering the intake manifold.

When the ignition is turned on, the solenoid valve closes, blocking off the float bowl-to-canister passage. The thermal vacuum valve vents control vacuum to the air cleaner until the engine reaches temperature above 95Β° F (35Β° C). Above the switching point, vacuum is applied to the purge control valve. Manifold vacuum pulls fresh air into the canister, through the purge line and into the intake manifold. This fresh air purges the fuel vapors from the canister.

Fig 1: Cross Section of Purge Line Check Valve
G09313789Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.