Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
NIPPONDENSO Electronic Ignition System: Overhaul: Reassembly
Reassemble distributor in reverse order of disassembly. Lightly grease timing rotor (reluctor) inner surface. Install on shaft, aligning "12" mark with stop. Install long spring on "14" side of timing rotor. Install Blue washer, spring, thin washer, bearing and thick washer on shaft in order. Install new pinion gear. Adjust pick-up coil air gap.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.