1973 Subaru DLFACTORY OEM SERVICE PROCEDURE

Steering Columns: Overhaul: Disassembly

Remove screws retaining column cover to steering column, then remove hazard warning switch knob and cover. To remove steering shaft, proceed as follows: Remove snap ring, spacer, washer, and rubber washer. Remove screws retaining housing and bearing assembly to steering column, then drive assembly out of column by using a screwdriver. Remove shaft from steering column.

Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.