2009 Smart Fortwo PureFACTORY OEM SERVICE PROCEDURE

Coolant temperature sensor, component description - GF07.04-P-6040MCC

ENGINE 132.9 in MODEL 451.3 /4 

Fig 1: Identifying Coolant Temperature Sensor
G07077258Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Location 

The coolant temperature sensor is screwed onto the left side on the cylinder head.

Task 

The coolant temperature sensor detects the coolant temperature and transmits a corresponding voltage signal to the ME-SFI [ME] control unit (N3/10).

Function 

The NTC resistor integrated within the coolant temperature sensor changes its electrical resistance according to the coolant temperature. The ME-SFI [ME] control unit applies a sensor voltage of 5 V to pin 1 (1) and evaluates signal voltage at pin 2 (2) according to the coolant temperature.

Fig 2: Identifying Coolant Temperature Sensor Connector Terminals
G07077259Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.