Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Smart Fortwo PureFACTORY OEM SERVICE PROCEDURE
TPMS Reset Procedures: Notes
NOTE:
A manual restart must be carried out for each change in tire inflation pressure, when replacing a wheel or a wheel sensor, as well as when replacing the TPM [RDK] control unit.
If the multifunction display shows a tire pressure warning message, immediately check air pressure of all tires and adjust to the specified pressure. Drive vehicle for 10 minutes to ensure malfunction has been corrected.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
