Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Smart Fortwo PureFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Grounds
GROUNDS LOCATION
| Component | Location |
|---|---|
| G3/1x1 | Rear of engine compartment. See Figure. |
| G3/2x1 | Rear of engine compartment. See Figure. |
| W6 | Behind rear bumper. See Figure. |
| W7 | Behind rear bumper. See Figure. |
| W9 | Near base of left "A" pillar. See Figure. |
| W9 | Left footwell. See Figure. |
| W10 | In battery compartment. See Figure. |
| W11 | Behind right rear bumper. See Figure. |
| W11/5 | Behind right rear bumper. See Figure. |
| W11/7 | On fuel filler neck. See Figure. |
| W14 | Left floor panel. See Figure. |
| W26 | In battery compartment. See Figure. |
| W30/2 | Under dash assembly. See Figure. |
| W43 | Behind front bumper. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.