Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Smart Fortwo PureFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Connectors
CONNECTORS LOCATION
| Component | Location |
|---|---|
| X4/40 | At center console. See Figure. |
| X4/41 | Top right passenger's floor pan. See Figure. |
| X10 | Left side of dash. See Figure. |
| X15 | Behind right taillight. See Figure. |
| X18/1 | Left "B" pillar. See Figure. |
| X18/19 | Left "B" pillar. See Figure. |
| X18/19.1 | Left rear of luggage compartment. See Figure. |
| X18/19.2 | Left rear of luggage compartment. See Figure. |
| X18/24 | Center rear of roof. See Figure. |
| X18/25 | Center rear of roof. See Figure. |
| X19 | Left "B" pillar. See Figure. |
| X20/1 | Behind third brake light. See Figure. |
| X23/7 | On left seat belt retractor. See Figure. |
| X23/7.1 | Left rear of luggage compartment. See Figure. |
| X23/7.2 | Right rear of luggage compartment. See Figure. |
| X26 | Left rear wheel well. See Figure. |
| X26/9 | Behind left headlamp. See Figure. |
| X26/91 | Behind left headlamp. See Figure. |
| X28/5 | Under passenger's seat. See Figure. |
| X28/6 | Right front floor support. See Figure. |
| X28/7 | Under passenger's seat. See Figure. |
| X28/8 | Right seat belt tensioner. See Figure. |
| X28/9 | Under passenger's seat. See Figure. |
| X30/7 | Under left side of dash. See Figure. |
| X35/1 | Left front of vehicle. See Figure. |
| X35/2 | Right front of vehicle. See Figure. |
| X39/45 | At glove box. See Figure. |
| X55/4 | Under passenger's seat. See Figure. |
| X57/6 | Left rear luggage compartment. See Figure. |
| X58/1 | Behind center of dash. See Figure. |
| X85/10 | Left side of dash. See Figure. |
| X237.2 | Right rear luggage compartment. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.