2013 Scion xB Automatic TransFACTORY OEM SERVICE PROCEDURE

Transmission Wire: Installation: Installation

  1. INSTALL TRANSMISSION WIRE 
    1. Coat a new O-ring with ATF and install it into the transmission wire.
      Fig 1: Transmission Wire O-Ring Location
      GTY166409Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Pass the transmission wire through the transaxle case.
    3. Install the transmission wire with the bolt.
      Fig 2: Removing/Installing Transmission Wire Components
      GTY157886Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

    4. Coat the O-ring on the ATF temperature sensor with ATF.
      Fig 3: Removing/Installing ATF Temperature Sensor
      GTY164952Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Install the ATF temperature sensor with the lock plate and bolt.

      Torque: 6.6 N*m (67 kgf*cm, 58 in.*lbf) 

    6. Connect the 5 shift solenoid valve connectors.
  2. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY 
    1. Install the 2 oil cleaner magnets onto the automatic transaxle oil pan sub-assembly, as shown in the illustration.
      Fig 4: Removing/Installing Oil Cleaner Magnets
      GTY157679Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the automatic transaxle oil pan sub-assembly and a new oil pan gasket with the 18 bolts.
      Fig 5: Removing/Installing Automatic Transaxle Oil Pan Sub-Assembly Components
      GTY159182Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 7.8 N*m (80 kgf*cm, 69 in.*lbf) 

  3. ADD AUTOMATIC TRANSAXLE FLUID 

    Fluid type

    Toyota Genuine ATF WS

  4. INSPECT AUTOMATIC TRANSAXLE FLUID  See step  1.
  5. INSPECT FOR AUTOMATIC TRANSAXLE FLUID LEAK 
  6. INSTALL NO. 1 ENGINE UNDER COVER 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.