Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Scion xD Automatic TransFACTORY OEM SERVICE PROCEDURE
Automatic Transaxle (Diagnostic Codes)
- Automatic Transaxle System
- DTC P0705: Transmission Range Sensor Circuit Malfunction (PRNDL Input)
- DTC P0711: Transmission Fluid Temperature Sensor "A" Performance
- DTC P0712: Transmission Fluid Temperature Sensor "A" Circuit Low Input; DTC P0713: Transmission Fluid Temperature Sensor "A" Circuit High Input
- DTC P0717: Turbine Speed Sensor Circuit No Signal
- DTC P0751: Shift Solenoid "A" Performance (Shift Solenoid Valve S1)
- DTC P0756: Shift Solenoid "B" Performance (Shift Solenoid Valve S2)
- DTC P0787: Shift / Timing Solenoid Low (Shift Solenoid Valve ST); DTC P0788: Shift / Timing Solenoid High (Shift Solenoid Valve ST)
- DTC P0973: Shift Solenoid "A" Control Circuit Low (Shift Solenoid Valve S1); DTC P0974: Shift Solenoid "A" Control Circuit High (Shift Solenoid Valve S1)
- DTC P0976: Shift Solenoid "B" Control Circuit Low (Shift Solenoid Valve S2); DTC P0977: Shift Solenoid "B" Control Circuit High (Shift Solenoid Valve S2)
- DTC P2714: Pressure Control Solenoid "D" Performance (Shift Solenoid Valve SLT)
- DTC P2716: Pressure Control Solenoid "D" Electrical (Shift Solenoid Valve SLT)
- DTC P2757: Torque Converter Clutch Pressure Control Solenoid Performance (Shift Solenoid Valve SLU)
- DTC P2759: Torque Converter Clutch Pressure Control Solenoid Control Circuit Electrical (Shift Solenoid Valve SLU)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
