2012 Scion xB Automatic TransFACTORY OEM SERVICE PROCEDURE

TPMS Reset Procedures: Notes

NOTE: The system will need to be initialized when tires are replaced with tires of different pressures; tire pressure sensor and/or tire pressure monitor ECU are replaced. See INITIALIZING TIRE PRESSURE MONITOR SYSTEMΒ . When a tire pressure sensor and/or tire pressure monitor ECU are replaced, the sensor ID must be memorized by the tire pressure monitor ECU prior to system initialization. See TIRE PRESSURE SENSOR REGISTRATIONΒ .

When the tire pressure warning light does not go off, or when it comes on during driving, check tire pressure and adjust as necessary. The warning light should turn off within a few minutes.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.