U760E AUTOMATIC TRANSMISSION / TRANSAXLE: TCM: INSTALLATION

1. INSTALL TCM

(a) Install the TCM to the automatic transaxle.

(b) Install and tighten the 2 bolts in the order shown in the illustration.

Torque : 11 Nm (115 kgf-cm, 8 ft-lbf)

(c) Connect the connector.

Text in Illustration

(d) Turn the lock lever and attach the claw to secure the connector.

2. INSTALL BATTERY CARRIER ASSEMBLY Installation

3. INSTALL BATTERY TRAY

4. INSTALL BATTERY

5. INSTALL BATTERY INSULATOR

6. INSTALL BATTERY CLAMP SUB-ASSEMBLY Installation

7. INSTALL AIR CLEANER CASE SUB-ASSEMBLY Installation

8. INSTALL AIR CLEANER CAP SUB-ASSEMBLY Installation

9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

10. CHECK AUTOMATIC TRANSAXLE SYSTEM

NOTICE:
If automatic transaxle parts are replaced, refer to Parts Replacement Compensation Table to determine if any additional operations are necessary Service Precautions.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Installation

Use the Manual With the Right Hardware

When to See a Mechanic