Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Scion tC L4-2.5L (2AR-FE)FACTORY OEM SERVICE PROCEDURE
Installation
DOOR LOCK: WIRELESS DOOR LOCK BUZZER: INSTALLATION
1. INSTALL WIRELESS DOOR LOCK BUZZER
(a) Connect the connector.
(b) Attach the clamp to install the wireless door lock buzzer.
2. INSTALL FRONT FENDER LINER LH
(a) Install the fender liner with the 9 clips.
(b) Install 3 new grommets.
(c) Install the 3 screws.
(d) Install the pin hold clip as shown in the illustration.
Text in Illustration
NOTICE:
Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.
3. INSTALL SIDE MUDGUARD SUB-ASSEMBLY LH
4. INSTALL REAR WHEEL HOUSE FRONT PLATE LH
5. INSTALL FRONT WHEEL
Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
