2012 Scion tC L4-2.5L (2AR-FE)FACTORY OEM SERVICE PROCEDURE

Transmitter Battery (W/O Smart Key System)





DOOR LOCK: TRANSMITTER BATTERY (W/O Smart Key System): REPLACEMENT

NOTICE:
Take extra care when handling these precision electronic components.

1. REMOVE TRANSMITTER HOUSING COVER

(a) Twist a screwdriver in the direction of the arrow in the illustration and remove the transmitter housing cover.

Factory service manual diagram




Text in Illustration

Factory service manual diagram




NOTICE:
Do not forcibly pry open the cover.

HINT
Tape the screwdriver tip before use.

2. REMOVE DOOR CONTROL TRANSMITTER MODULE

(a) Using a precision screwdriver, remove the door control transmitter module.

Factory service manual diagram




Text in Illustration

Factory service manual diagram




HINT
Tape the screwdriver tip before use.

3. REMOVE TRANSMITTER BATTERY

(a) Detach the 2 claws and remove the transmitter battery cover.

Factory service manual diagram




(b) Using a precision screwdriver, remove the battery (lithium battery: CR2016).

Factory service manual diagram




Text in Illustration

Factory service manual diagram




NOTICE:
* Do not push the terminals with your finger.
* Do not forcibly pry up the battery. The terminals may become damaged.
* Do not touch the battery with wet hands. Water may cause rust.
* Do not touch or move any components inside the transmitter. It may interfere with proper operation.
* When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the door control transmitter module set from being damaged.

HINT
Tape the screwdriver tip before use.

4. INSTALL TRANSMITTER BATTERY

(a) Install a new battery (lithium battery: CR2016) with the positive (+) side facing upward as shown in the illustration.

Factory service manual diagram




NOTICE:
* Do not bend the transmitter battery electrode during insertion.
* Keep the transmitter cover interior free of dust and oil.
* When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the door control transmitter module set from being damaged.

(b) Attach the 2 claws to install the transmitter battery cover.

Factory service manual diagram




5. INSTALL DOOR CONTROL TRANSMITTER MODULE

Factory service manual diagram




(a) Install the door control transmitter module.

6. INSTALL TRANSMITTER HOUSING COVER

(a) Install the transmitter housing cover to the transmitter housing case.

Factory service manual diagram




(b) Check that the transmitter LED illuminates 3 times when a switch is pressed 3 times.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.