2012 Scion tC L4-2.5L (2AR-FE)FACTORY OEM SERVICE PROCEDURE

Removal





DOOR LOCK: DOOR CONTROL RECEIVER: REMOVAL

1. REMOVE REAR SEAT ASSEMBLY

Removal

2. REMOVE FRONT DOOR SCUFF PLATE LH Removal

3. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH Removal

4. REMOVE DOOR CONTROL RECEIVER

(a) Disconnect the connector.

Factory service manual diagram




Text in Illustration

Factory service manual diagram




(b) Remove the bolt and receiver.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.