Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC P0101: Mass Air Flow Circuit Range / Performance Problem: Procedure
- CHECK FOR ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0101)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine / Trouble Codes.
- Read the DTCs.RESULT
Result Proceed to P0101 is output A P0101 and other DTCs are output B HINT:
If any DTCs other than P0101 are output, troubleshoot those DTCs first.
B → See step 6
A: Go to next step
- CHECK AIR INDUCTION SYSTEM
- Check the air induction system for vacuum leaks. Refer to ON-VEHICLE INSPECTION - Step 1
.
OK
No leaks in air induction system.
NG → See step 7
OK: Go to next step
- Check the air induction system for vacuum leaks. Refer to ON-VEHICLE INSPECTION - Step 1
.
- CHECK PCV HOSE CONNECTIONS
- Check the PCV hose connections.
OK
PCV hose is connected correctly and is not damaged.
NG → See step 8
OK: Go to next step
- Check the PCV hose connections.
- REPLACE MASS AIR FLOW METER SUB-ASSEMBLY
- Replace the mass air flow meter sub-assembly. Refer to REMOVAL .
NEXT: Go to next step
- CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Clear the DTCs. Refer to DTC CHECK / CLEAR .
- Turn the ignition switch off and wait for 30 seconds.
- Turn the ignition switch to ON and turn the Techstream on.
- Start the engine and warm it up.
- Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
- Enter the following menus: Powertrain / Engine / Utility / All Readiness.
- Input the DTC: P0101.
- Check the DTC judgment result.RESULT
Techstream Display Description NORMAL - DTC judgment completed
- System normal
ABNORMAL - DTC judgment completed
- System abnormal
INCOMPLETE - DTC judgment not completed
- Perform driving pattern after confirming DTC enabling conditions
N/A - Unable to perform DTC judgment
- Number of DTCs which do not fulfill DTC preconditions has reached ECU memory limit
NEXT → END
- GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART
- REPAIR OR REPLACE AIR INDUCTION SYSTEM. Refer to REMOVAL
- REPAIR OR REPLACE PCV HOSE. Refer to REMOVAL
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
