Rear Speed Sensor: Removal: Removal

HINT: 

• Use the same procedure for the RH and LH sides.
• The procedure listed below is for the LH side.

1. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH 

   Refer to REMOVAL

2. REMOVE REAR WHEEL 
3. DISCONNECT REAR DISC BRAKE CYLINDER ASSEMBLY LH  . Refer to REMOVAL - Step 14
4. REMOVE REAR DISC  . Refer to REMOVAL - Step 15
5. REMOVE SKID CONTROL SENSOR WIRE LH 
   1. Disconnect the skid control sensor wire connector from the vehicle side connector on the rear floor.
   2. Disconnect the grommet of the skid control sensor wire from the hole of the wheel house.
      Fig 1: Identifying Skid Sensor Wire Grommet

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Remove the bolt and sensor clamp from the wheel house gusset.
      Fig 2: Removing Wheel House Gusset.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   4. Remove the bolt and sensor clamp from the trailing arm bracket.
      Fig 3: Removing Trailing Arm Bracket

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   5. Detach the sensor clamp.
      Fig 4: Identifying Sensor Clamp

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   6. Disconnect the connector.
6. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH 

   Refer to REMOVAL - Step 9

   HINT: 

   • The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly.
   • If the sensor rotor needs to be replaced, replace it together with the rear axle hub and bearing assembly.